Are Kingdom + Sand

CR99 · Posted: Fri Nov 09, 2007 12:33 pm Post subject: Are Kingdom + Sand

Hey, my Ares Kingdom Failsafe MLP Die Hard is full of sparkling sand. The sound hurts while pulling the vinyl out of the jacket. And I can't clean it.
What's that stuff?

NWN PROD · Joined: 10 May 2006 Posts: 13633 Location: SF Bay Area

It is vinyl dust from the colored vinyl process. Just clean it off.
_________________
The only email I have access to is nwnprod (at) gmail (dot) com. I do not have access to my old Yahoo addresses.

Guest · Posted: Fri Nov 09, 2007 2:53 pm Post subject:

wash it with water and soapbar....

it works nice.

just take care of the center labels, don't let them get wet.

then you can dry your lp with a soft cotton towel.

CR99 · Posted: Fri Nov 09, 2007 2:55 pm Post subject:

??? I think water damages the vinyl surface?

Guest · Posted: Fri Nov 09, 2007 3:11 pm Post subject:

Just dry it very well...

Vinyl is nothing but plastic.

monsterSquad · Joined: 16 Aug 2007 Posts: 700

i used that "air in a can" shit and blew off the dust, then a very soft cloth with a little drop of vinyl cleaner i got from sleeve city

that did the trick. but don't forget to replace the sleeve the record sits in because that has some vinyl dust in it too

NWN PROD · Joined: 10 May 2006 Posts: 13633 Location: SF Bay Area

I usually use distilled water and rubbing alcohol mix. I would avoid using bar soap since it will most likely leave residue on your vinyl.
_________________
The only email I have access to is nwnprod (at) gmail (dot) com. I do not have access to my old Yahoo addresses.

Guest · Posted: Fri Nov 09, 2007 4:50 pm Post subject:

Oh yeah....don't use the bar directly onto the vinyl, just the soap !